High Speed Welding Edelbrock Exhaust Mod Post 1
-
The guys at High Speed Welding are finishing up the exhaust and it should be done by the end of the week.
The goal is to tuck the exhaust up tight to the stock floor pan.
Close up of the new downpipes on the shorty headers
You can see that nothing is hanging below the Stock Sub-Frame as the car will be 5 1/2″ off the ground.
In order to tuck the muffler tight to the floor they had to raise a section of the stock floor pan.
It was very important to keep the factory rear seat for my girls to ride in.
Finished front half of the exhaust.
The G-Force cross member made tucking the exhaust up easy. This is a great piece !
Up and over the axle is going to be exciting as the car has been lowered 3″ in the rear so it’s going to be a tight squeeze.
I love how pictures make things look closer then they actually are.
