Installing the Ride Tech Rear Brackets


  • While the car was at High Speed Welding the guy’s flattened the passenger side bracket to match this cars floor pan. Very simple tweak that had to be done. Even though these parts are meant to be bolt-on some-times they require a little work to fit better.

    After some discussion Dennis at High Speed Welding felt it was important to retain the hardware supplied by Ride-Tech and to weld the brackets to the stock subframe to help distribute the load on the stock frame rails.


    March 26th, 2012 | Marty | No Comments |

Leave a Reply

You must be logged in to post a comment.